Jesee delivers independent inspection for protective coating systems, including paint and galvanizing etc. Our services ensure your corrosion protection meets specifications, both at the workshop and on-site.
Our coating inspection services cover a wide range of protective coating systems applied to structural steelwork — from fabrication workshop to final site installation.
Beams, columns, trusses and fabricated steel members with paint or galvanising systems applied during fabrication or on site.
Bridge girders, bearings and structural components where long-term corrosion protection is critical to structural integrity and service life.
Heavy steel structures in aggressive environments where coating performance directly impacts maintenance cycles and operational safety.
We apply the appropriate inspection technique at every stage of the coating process — from surface preparation through to final coat application — to verify full compliance with your coating specification.
Precise measurement of paint coating thickness using calibrated digital gauges, verified against specified DFT requirements for each coat and the total system.
Non-destructive measurement of hot-dip galvanised coating thickness on structural steel components, assessed against project specifications and applicable standards.
Pull-off and cross-cut adhesion tests to verify the bond strength of paint coatings to the substrate — a critical indicator of long-term corrosion protection performance.
Our coating inspection process follows the full application cycle — from surface preparation through to final coat — ensuring every stage meets specification before the next begins.
1
We review your coating specification, surface preparation requirements and applicable standards to establish clear inspection and acceptance criteria before work begins.
2
We verify that surface cleanliness and profile meet the specified requirements prior to coating application — the most critical stage for long-term coating performance.
3
Thickness and adhesion measurements are taken at each coat stage and upon completion, with all readings documented against the specified DFT requirements.
4
A full inspection report is issued with measurement records, photographic evidence and pass/fail assessment — ready for submission to your client or project authority.
Talk to our coating inspection specialists today — we’ll ensure your corrosion protection system meets specification at every stage, from surface preparation through to final application.
Results accepted by clients and authorities.
Based in Shenzhen and Hong Kong, ready to deploy at short notice.
